Back to Course

PCB DESIGNING AND MANUFACTURING

0% Complete
0/0 Steps
  1. INTRODUCTION
    4 Topics
  2. CONDUCTOR AND CONDUCTIVE PATHS
    3 Topics
  3. ZERO PCB
  4. OVERVIEW OF ELECTRONICS
    4 Topics
  5. CLASSIFICATION OF PCB
    2 Topics
  6. EAGLE OVERVIEW
    2 Topics
  7. COMPOSITION OF PRINTED CIRCUIT BOARD
    3 Topics
  8. BRIEF ABOUT COPPER
  9. COLOR OF THE PRINTED CIRCUIT BOARD
  10. PCB MANUFACTURING
  11. PCB DESIGNING
    2 Topics
  12. PCB DESIGNING SOFTWARE
    3 Topics
  13. SCHEMATIC STUDY
    4 Topics
  14. PCB TERMINOLOGIES
    13 Topics
  15. ROUTING
    5 Topics
  16. GERBER GENERATION
    4 Topics
  17. GROUND PLANE
  18. BILL OF MATERIAL
    1 Topic
  19. MISCELLANEOUS ACTIVITY
    1 Quiz
  20. ROUTING RULES
    6 Topics
  21. ACTIVITY 1
    1 Quiz
  22. ACTIVITY 2
    1 Quiz
  23. ACTIVITY 3
    1 Quiz
  24. ACTIVITY 4
    1 Quiz
  25. SCHEMATIC DESIGN
    13 Topics
  26. LAYOUT DESIGN
    8 Topics
  27. ERC
    8 Topics
  28. DRC
    3 Topics
  29. ACTIVITY 6
    1 Quiz
  30. Activity 7
    1 Quiz
  31. ACTIVITY 8
    1 Quiz
  32. ACTIVITY 9
    1 Quiz
  33. ACTIVITY 5
    1 Quiz
  34. ASSIGNMENT 1
    2 Topics
  35. ASSIGNMENT 2
    1 Topic
  36. MISCLLANEOUS ASSIGNMENT
    1 Topic
In Progress
Lesson 37 of 36
In Progress

KEY POINTS TO START PCB DESIGNING

26/07/2021

There are four key points to remember to start a PCB designing:

  1. Schematic study
  2. Size of the PCB
  3. Type of the PCB
  4. Fix Placement of the components.

SCHEMATIC STUDY: Schematic study took a major role in PCB designing . One should always know to study the schematic diagram and to create the proper schematic diagram. Before moving into the board design one should check all the errors that might be possible while creating the Schematic Diagram. 

SIZE OF THE PCB: Size of the PCB is the second most important part to start the PCB designing. One should always know the required size of the board before getting started into it.

TYPE OF THE PCB: One should always know the requirement of the clients whether they need single layer or double layer PCB. One Should always know whether the client needs through hole components or surface mount components.

FIX PLACEMENT OF THE COMPONENTS:  Before getting in to the board section, one should always confirm whether the components used from the library are as per the requirements. This should be done on the schematic part.