Back to Course

Basics of Electronics

0% Complete
0/0 Steps
  1. Lesson-1-> Introduction to basic Electronics fundamental concepts.
    4 Topics
    |
    1 Quiz
  2. Lesson -2-> Introduction to Breadboard
    4 Topics
    |
    1 Quiz
  3. Lesson-3 -> Introduction to LED
    4 Topics
    |
    1 Quiz
  4. Lesson-4->Introduction to switches
    4 Topics
    |
    1 Quiz
  5. Lesson-5-> Introduction to Transistor and voltage regulator
    4 Topics
    |
    1 Quiz
  6. Lesson-6 -> Introduction to capacitor
    5 Topics
    |
    1 Quiz
  7. Lesson-7->Introduction to Relay and diode
    4 Topics
    |
    1 Quiz
  8. Activity-1->How to turn on/off multiple LED’s using a slider switch
    4 Topics
    |
    1 Quiz
  9. Activity-2->How to use transistor as a switch and amplifier
    3 Topics
    |
    1 Quiz
  10. Activity-3->How to make a LDR project with transistor
    3 Topics
    |
    1 Quiz
  11. Activity-4->How to make a charging and discharging circuit of capacitor
    3 Topics
    |
    1 Quiz
Lesson 8, Topic 1
In Progress

Introduction-> How to turn on/off multiple LED’s using a slider switch

07/10/2021
Lesson Progress
0% Complete

Introduction to the project

  • In this project, we will be interfacing three Led’s with a slider switch.We will be using an Online software, Tinkercad. Tinkercad is a free online software where we can design and test our circuit with live simulations (Refer Arduino Coding course for further knowledge).

  • In this project we will take three led’s and connect all the three led’s in series.There will be a single slider switch which is used to control(Switch ON/OFF) all the led’s.

Components Required:

  1. LED x3

  2. Slider Switch x1

  3. Resistor (220 ohm) x1

  4. Breadboard x1

  5. 9V battery x1

  6. Jumper Wires x1